Point soldering system

Point Job Data Settings Point job data is a set of commands and logic operations that is performed at job points. The point soldering system will perform point jobs selected from the point job number list on the point settings screen. (See “POINT JOB DATA” on Page 59 of the Teaching Pendant Operation manual for details) Depending on the point type set to the point, selection may not be possible. (See the table on Page 22) You can create point job data Nos. 01 – 100 in the Teaching mode. Point job data Nos. 101 – 200 can be created in the Customizing mode.

[Point Job] set at the work home position is performed at the work home position coordinates only when the tool center point is placed above the work home position after a cycle of operation. [Job while CP Moving] is performed repeatedly while shifting from the work home position to the next (first) point. [Job before Moving] and [Job while Moving] are performed while the point soldering system Axes are returning from the last point of the program to the work home position after a cycle of operation.

The following C & T data is saved on both the point soldering system and the PC as well as transmitted between them. The administration mode data and teaching environment setting data will not be deleted even if the power to the robotic point soldering system is turned off.

The robotic point soldering system operates in five major mode categories, one of which is the Administration Mode. When the robotic point soldering system is active in this mode, the 「ADMIN」LED on the Teaching Pendant is lit. Within the Administration Mode, there are four other modes, namely Administration Settings Mode, Diagnostic Mode, Mechanical Adjustment Mode, and Version Information Display Mode.